Remove the hard drive cage from the chassis by simply sliding it outward. A cheap and charming color laser printer A cheap and charming color laser printer by Dan Ackerman. Description of the error. Insulation must not be frayed or worn. To reinstall the bezel, align the plastic tabs on the right side of the bezel with the corresponding holes in the chassis, then pivot it inward until it snaps into position on the left side.
|Date Added:||21 June 2016|
|File Size:||46.40 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Reseat the hard disk drive cable 4. When the computer lenkvo turned on for the first time after battery replacement, an error message might be displayed. Reposition any cables that might impede the replacement of the computer cover. Safety notices multi-lingual translations The caution and danger safety notices in this section are provided in the following languages: Release the optical drive from the drive bay assembly by pressing inward on the blue retainer at the side of the drive.
You can find the following information: Route the fan cable to the system board and connect the cable to the system board. Replacing the power supply. Use a slow lifting force. Power Cord Check the power-on switch for continuity. Make sure the hard disk drive is correctly installed. Press down on the metal latch 2 and pivot in the drive cage into place.
This message displays during a full memory test, counting down the memory areas being tested. Otherwise, your changes will not be saved.
To secure the microprocessor in the socket, close the microprocessor retainer and lock it into position with the small handle. Note the front panel assembly cable routing and remove the assembly from the chassis.
If you are responsible for maintaining the settings of several computers, you might want to set an Administrator Password.
Replace the component called lejovo in warning statement 4.
Align the drive bay assembly studs with the two slots on lennovo sides of the chassis and place it into position. Has this lenvo ever worked? Nicht in den Strahl blicken. Align the drive bay assembly with the two slots and rails on the sides of the chassis, reconnect the drive cables on the system board, and then slide the drive bay assembly towards the rear of the chassis until it snaps into position.
Also remove the screw that secures the power supply 7089 the front. System Board Program loads from the hard disk with a known-good diagnostics diskette in the first 3. Removing and replacing the front bezel Replacing the power supply. If no hard disk drives are installed, make sure the hard disk drive selection in Setup is set to NONE. Hard Disk Drive Cable 2.
Install the new optical drive into the bay and slide it to the locked position. Replacing FRUs – Tower Computers Replacing the front fan assembly This procedure describes how to remove and replace the front fan assembly.
Cache, if removable 2.
Problem determination tips Due to the variety of hardware and software combinations that can be encountered, use the following information to assist you in problem determination. The power control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device.
Only the major FRUs are documented.
Important Do not touch the circuit board on the bottom of the hard disk drive. Attach power cords to outlet.
Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.